A puddle under the tank sends most people straight to the hardware store, and that is the wrong first stop. Trace the water first. If it drips from a pipe connection, a valve or the relief line, a repair is realistic. If the tank body itself is weeping, a new unit is in your future. Everything we arrange on heaters sits under water heaters, and the quote page starts a visit.
Which part of the heater is dripping?
Towel the jacket and floor dry, then wait for the first bead of water to show. Beads at the top usually trace to the inlet or outlet fittings. A thin pipe running down the side that is wet at its tip belongs to the relief valve. Wetness at the low front corner is the drain valve. A bead with nothing above it implicates the tank.
Work through the suspects top to bottom:
- Cold and hot pipe connections at the top. A slow drip at this height runs down the jacket and fools people.
- The relief valve and its discharge pipe. If the pipe end near the floor is wet, the valve is opening. Never cap it.
- The drain valve near the bottom. A drip from its spout points to a worn valve seat.
- Condensation. A sweating cold pipe can drip onto the heater and imitate a leak. Wipe it, wait, and see.
- The tank base. Moisture that returns with nothing wet above it is a tank problem.
Photograph the wet spot and the rating label. Those two pictures often give the plumber enough to start pricing.
Is a leaking tank worth fixing?
Almost never. Once water escapes through the steel shell, nothing durable can be patched on, so replacement is the answer. Thumbtack's repair guide calls leaks generally not affordable to repair unless a warranty applies. Fittings, valves and thermostats are the pieces that actually get repaired.
A sacrificial anode rod sits in the tank to rust first, sparing the steel. Rheem's manual says to remove it once a year for inspection and replace it when more than 6 inches of core wire is exposed at either end. When it is used up, older tanks tend to fail sooner, which is the subject of anode rod water heater replacement.
Local water matters too. Cucamonga Valley Water District reported a total hardness range of 109 to 142 ppm in 2025, averaging about 125. Using the usual conversion, that is roughly 7 grains per gallon, moderately hard. Scale builds up in tanks over time, and flushing helps. Homes in the Upland foothills may be on a different water supplier, so look at your bill.
What do I do right now while it is dripping?
Remove the heat source, stop the incoming water, and catch what escapes. An electric unit goes off at its breaker; a gas unit's dial goes to off or pilot. Shut the cold supply valve above the tank. Slide a pan under the drip and keep children and pets clear of hot water.
Gas has its own rule. A rotten-egg smell means everyone outside, then SoCalGas at 1-800-427-2200, or 911 if they do not answer. Searching for the source indoors is not your job.
Hold off draining a tank that has just been heating. Rheem's manual flags a scald hazard at both the relief valve and the drain. Close the main if the cold valve is stuck or hidden. When the leak is also darkening drywall or a ceiling below, treat it as urgent; emergency water heater repair deals with that case.
Which of these leaks are a homeowner job?
Snugging a loose flexible connector, replacing a worn drain valve or swapping a cracked supply hose are fair game once the water and fuel are off. Gas piping, venting and anything that needs a permit are contractor work in California, and that is where your own effort should stop.
A dripping relief valve is its own puzzle. Rheem's manual blames thermal expansion in a closed system for periodic discharge and says a new valve will not cure it; the suggested fix is an expansion tank on the cold line. Do not plug the outlet or fit a valve upstream of it. More in water heater relief valve replacement.
Three shortcuts to avoid: epoxy smeared on the tank, tape around a leak, and a cap on the relief line. Each hides a hazard instead of fixing it.
Does the brand change how a leak is handled?
Brand changes the replacement parts, not the detective work. A Rheem, a Whirlpool and a Bosch all leak from the same few places: fittings, valves, drains or the tank. Find the manual for your exact model, since it carries that heater's rules, and keep the label numbers handy.
The Rheem manual is the only one I read for this page, so the valve, discharge-line and anode guidance here comes from it. I have not checked Whirlpool or Bosch literature and will not pretend otherwise. If yours is one of those, say so on the request so the visit is matched to that brand's parts and warranty.
Warranty is worth a look. A tank that leaks while the manufacturer's warranty is still running may be replaced under its terms, though labor is often not included. Read the card before assuming.
What does a water heater repair cost?
Thumbtack's national guide, updated October 2026, shows $297 to $1,198 for a typical water heater repair. A thermostat or element swap sits at $150 to $200, and cleaning and repairing a thermocouple at $395. Its replacement examples are about $1,000 for electric and $1,100 for gas, before code upgrades.
| Job | National guide figure |
|---|---|
| Thermostat or element replacement | $150 to $200 |
| Thermocouple clean and repair | $395 |
| Typical repair visit | $297 to $1,198 |
| Replacement, 50-gallon electric (example) | about $1,000, before code upgrades |
| Replacement, gas (example) | about $1,100, before code upgrades |
After-hours timing, a tank wedged in a closet or attic, and permit fees all push the total. Replacement is its own subject in water heater replacement cost.
These come from a national guide, not from Rancho Cucamonga jobs, so your real price is whatever a local plumber writes on your quote.
Why would a heater stop heating after a leak?
Usually it has lost power, fuel or water. Look at the breaker or pilot, confirm the cold valve is open, and press the reset on an electric unit's high-limit switch. If none of that works, the element, thermostat or gas control is next in line, and that needs a plumber.
On gas models, a pilot that keeps dying often points to the thermocouple, the $395 item in the table. Stop pressing the igniter if you smell gas.
Plenty of cold-shower mornings have no leak behind them. One dead element in a dual-element tank leaves water lukewarm; a bad thermostat makes temperatures erratic; sediment can smother a gas burner. Why there is no hot water runs the checks in order, and replacement water heater elements covers that part.
Is a do-it-yourself tankless install realistic?
I would not recommend it. Gas tankless units commonly need a bigger gas line, matched venting and a condensate drain, and gas piping is contractor work in this state. A replacement of any heater typically needs a city permit, and state law expects heaters to be strapped against earthquakes under Health and Safety Code 19211.
Rancho Cucamonga's Building and Safety office takes permit applications online rather than over the counter; ask how your job is treated at (909) 488-4668. A swap done without a permit can surface later during a sale or an insurance claim.
Choosing between styles? Tank vs tankless weighs them, and tankless installation cost explains the price drivers. Your own homework is measuring the space, noting the fuel, and asking about vent and gas line changes.
Common questions
How much time should I set aside?
That hinges on the source. A new valve or fitting is a brief visit; a full tank swap takes far longer, since the old unit is drained, hauled out and the new one strapped. I cannot verify hour counts, so request a time estimate with your quote.
What questions belong on my list before booking?
Get a license number and verify it at cslb.ca.gov. Then find out if pricing is flat or by the hour, if a trip fee applies, if the permit is included, and what the plan is if the tank proves beyond repair. Have the answers typed on the quote.
Must an adult be at the house during the work?
Plan on it. Someone needs to point out the heater, shutoffs and leak, and to okay the scope. Clear a path to the tank first, particularly in a garage or closet, and mention gates, dogs or tight access when you request the visit.
This guide is one of many on plumber across Rancho Cucamonga.
Sources used
- Rheem, residential electric water heater use and care manual
- Thumbtack, water heater repair cost (updated Oct 2026)
- Cucamonga Valley Water District, 2025 Water Quality Report
- California Health and Safety Code section 19211, water heater strapping
- City of Rancho Cucamonga, Building and Safety
- SoCalGas, what to do about a natural gas leak
Updated